Pcie Expansion Cards - Supermicro SuperServer SYS-510D-4C-FN6P User Manual

3.6 PCIe Expansion Cards

The system supports an optional riser card to allow a full-height, half-length expansion card
to fit inside the chassis. Use the RSC-S-6G4 to install a PCIe x16 card.
Note: Install the expansion card after installing the 2.5" solid-state disk drives.
Assemble the PCIe Expansion Card, Riser Card, and Brackets
1. Remove power as described in Section 3.1 and remove the chassis cover.
2. Remove the expansion card clip and the PCI slot shield.
3. Outside of the chassis, create a riser card assembly by installing the riser card to the
riser card bracket.
4. Create a PCI card assembly by installing a PCI slot bracket to the expansion card.
5. Insert the PCI card assembly into the riser card assembly.
Chapter 3: Maintenance and Component Installation
PCI Slot Shield
Figure 3-5. Expansion Card Clip Location
Expansion Card Configurations
Slot Mechanical
1
Full height, half length
Full height = 4.2", Low profile = 2.5",
Full length = 9.5", Half length = 6.6"
31
1
Expansion
Card Clip
Electrical
x16