Black Balance Adjustment; Automatic Adjustment - Panasonic AW-UE150KP Operating Instructions Manual

Black balance adjustment

Adjust the zero levels of the three primary colors (RGB) to reproduce
black accurately. If the black balance is out of adjustment, not only will
black be reproduced poorly, but the color tones of the screen as a whole
will also be degraded.
Readjustment of the black balance is not required under normal
circumstances but is necessary in the following situations.
• Perform adjustment when using the unit for the first time or when
the unit has not been used for a prolonged period.
• Perform adjustment when the ambient temperature changes
significantly, such as during changes of the season.
<NOTE>
• After adjusting the black balance, and [Serial] or [IP] of [Tracking Data
Output] is set to [On], the tracking data output may be delayed or the
value may not be updated. (→ page 61)

Automatic adjustment

When performing operations from a wireless
remote control
The procedure is identical to that of "Automatic adjustment"
(→ page 39) in "White balance adjustment".
The black balance can be configured by performing automatic white
balance adjustment (AWB) and automatic black balance adjustment
(ABB).
• The white balance will also be configured, so be sure to prepare
the conditions for white balance adjustment before performing the
procedure.
• Adjustment cannot be performed while the color bar is displayed.
Switch to the camera image by pressing the <MODE> button.
• The black balance cannot be adjusted during preset playback.
When performing operations from a controller
When using an AW‑RP150
For details, refer to the operating instructions for the controller.
41