Panasonic AW-UE150KP Operating Instructions Manual page 113

Web screen configurations (continued)
z MPEG2‑TS over UDP
„
Make settings for MPEG2-TS over UDP transmission.
<NOTE>
• In order to receive the images being transmitted by the camera, enter
the following URL in the application or service.
- For Unicast
udp://@[unicast ipaddress]:[unicast port]
- For Multicast
udp://@[multicast ipaddress]:[multicast port]
Transmission type [Unicast, Multicast]
Sets the transmission type for MPEG2-TS over UDP transmission as
either Unicast or Multicast.
Factory settings: Unicast
Unicast address(IPv4)
Sets the Unicast address used for MPEG2-TS over UDP
transmission.
Specify this IP address on the receiving application or service.
Factory settings: 192.168.0.3
Unicast Port [1024 to 50000]
Sets the Unicast port number used for MPEG2-TS over UDP
transmission.
Specify this port number on the receiving application or service.
Factory settings: 7002
Multicast address(IPv4)
Sets the Multicast address used for MPEG2-TS over UDP
transmission.
Specify this IP address on the receiving application or service.
Factory settings: 239.192.0.20
Multicast Port [1024 to 50000]
Sets the Multicast port number used for MPEG2-TS over UDP
transmission.
Specify this port number on the receiving application or service.
Factory settings: 32004
Multicast TTL/HOPLimit
The same as H.264 Multicast TTL/HOPLimit (→ page 108).
Push UDP [Enable, Disable]
When [Push UDP] has been set to [Enable], MPEG2-TS over UDP
transmission starts automatically when the camera is started.
Factory settings: Enable
Streaming format
Make settings for H.264 images used for MPEG2-TS over UDP
transmission.
The setting is confirmed with the [Set] button.
Refer to the description of H.264 (→ page 107) for information about
Image capture size, Frame rate, and Max bit rate(per client).
<NOTE>
• Streaming format settings cannot be changed during MPEG2-TS
over UDP transmissions.
• When [IP(UDP)] of [Tracking Data Output] is set to [On], video
transmission via IP may be delayed or the video may suffer frame
loss. (→ page 128)
We recommend [IP(UDP)] of [Tracking Data Output] is set to [Off]
during MPEG2-TS over UDP transmission.
113