Selecting The Units - Panasonic AW-UE150KP Operating Instructions Manual

Selecting the units

Select the unit (or units) to be operated from the wireless remote control
or controller.
Even when using only one unit, it must still be selected.
When performing operations from a wireless
remote control
Up to four units can be operated using one wireless remote control.
To select the unit using the wireless remote control, the IR ID switches
on the unit's back panel must be set.
For details of the IR ID switch settings, refer to page 17 and page 27.
1.
Press the <CAM1>, <CAM2>, <CAM3>, or <CAM4>
button.
The unit's status display lamp blinks green when a signal matched by
the remote control ID has been received, and it blinks orange when a
signal that is not matched by the remote control ID has been received.
When performing operations from a controller
A maximum of five units can be operated by one controller when using
serial control.
When using an AW‑RP150
For details, refer to the operating instructions for the controller.
• Network connection with AW-RP150 requires setup of an initial
account. (→ page 29)
When an initial account is not set up, AW-RP150 can detect but
cannot control this unit.
• When operating the camera on a network with a controller, such as
the AW-RP150, and [Serial] or [IP] of [Tracking Data Output] is set to
[On], the tracking data output may be delayed or the value may not be
updated. (→ page 61)
32