Tools & Parts; Specifications - Maytag Commercial MGD20MNTGW Installation Instructions Manual

TOOLS & PARTS TOOLS & PARTS
Tools Needed:
8" or 10"
Pipe Wrench
TORX T-20 Security
†
Screwdriver or Bit
Level
Caulk Gun and Caulk
(for installing new exhaust vent)
Flashlight (optional)
Parts Supplied:
Foot Boots (4)
NOTE: The circuit diagram for this dryer is located inside
the lower front panel, within the Tech Sheets.
Technical Specifications:
220–240 V, 50 Hz AC
4575 W
Total mass: 68 kg maximum
These units are sold in multiple regions with different
requirements for measuring capacity. Below are a few of
the valid forms of measure posted on this product:
Dry Linen Capacity: A weight measure that reflects a minimum
threshold for dry volume capacity that is needed for import
tariff purposes.
IEC Capacity: The capacity measure that represents the
maximum capacity of dry linens and textiles which the
manufacturer declares can be treated in a specific cycle.
TORX and T20 are trademarks of Acument Intellectual Properties, LLC.
†
8
8" or 10"
Adjustable Wrench
(that opens to 1")
1" Hex-Head
Socket Wrench
Utility Knife
Vent Clamps
1" Open-End Wrenches
Leveling Legs (4)
Flat-Blade Screwdriver
5⁄ 16" Socket Wrench
1/4" Nut Driver
Pipe-Joint Compound
Suitable for Gas Type
Ruler or Measuring Tape
Security Cone

SPECIFICATIONS

SPECIFICATIONS
Dry Linen Capacity
10.5 kg (23 lbs)
IEC Capacity
10.5 kg (23 lbs)
Sound Level
LpA: 58 dB(A) (kPa+/-10 dB(A))
Phillips Screwdriver
Pliers (that open to 1 / ")
9
16
27"
Wood Block
Putty Knife
5/16" Hex Head – 18 x 2 ⁄ "
1
2
Security Bolt