Table of Contents
Advertisement
Available languages
Available languages
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed:
200 mm (8") or 250 mm
I
(10") Pipe wrench
200 mm (8") or 250 mm
I
(10") Adjustable wrench
Flat-blade screwdriver
I
Phillips screwdriver
I
Adjustable wrench that
I
opens to 25 mm (1") or
hex-head socket wrench
Level
I
Parts supplied:
Remove parts bag from dryer drum. Check that all parts were
included.
Foot boot (4)
I
Dryer foot (4)
I
PD models: Cam for
I
service door lock
NOTE: The circuit diagram for this dryer is located inside the
lower front panel, within the Tech Sheets.
4
All manuals and user guides at all-guides.com
DRYER DISPOSAL
INSTALLATION REQUIREMENTS
8 mm (
5
/
) socket wrench
I
"
16
Utility knife
I
Vent clamps
I
Pipe-joint compound
I
resistant to LP gas
Sealing gun and sealing
I
compound (for installing
new exhaust vent)
Pliers
I
Stiff-bladed putty knife
I
PN models: Card reader
I
bezel, card reader wire
harness, hardware
Location Requirements
If installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
I Check code requirements: Some codes limit or do not permit
installation of clothes dryers in garages, closets, or sleeping
quarters. Contact your local building inspector.
I Make sure that lower edges of the cabinet, plus the back and
bottom sides of the dryer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See
"Recessed Area and Closet Installation Instructions" below
for minimum spacing requirements.
I Do not install on carpet.
NOTE: The dryer must not be installed in an area where it will be
exposed to water and/or weather.
Advertisement
Table of Contents
