Specifications; Reset Circuit - Renesas R0E5562GAPFK10 User Manual

R0E5562GAPFK10

3. Specifications

Table 2 shows the functional specifications of this product.
Table 2 Specifications of this product
Item
MCU for use
The MCU type name
installed on this product
Power supply
System clock (EXTAL)
Notes*:1. Please use it by voltage (VCC > V

4. Reset Circuit

Figure 2 shows the reset circuit, with the level on the RES# pin pulled up by a 510-kΩ resistor.
38-pin connector (CN1)
510 kΩ
Pin 9
1
(RES#)*
Notes* : 1. Indicated pin numbers are for pins of the 38-pin connector (CN1).
Figure 2 Reset Circuit
R20UT2114EJ0100 Rev.1.00
Sep 05, 2012
Specification
• RX62T and RX62G groups MCUs in PLQP0064KB-A packages
• R5F562GABDFH (exclusive for debugging)
(ROM: 256 Kbytes, RAM: 16 Kbytes, Data flash: 32 Kbytes )
• Power(VCC) at 2.7
*1
to 3.6 V, or 4.0 to 5.5 V is supplied from the user system.
• Power(AVCC0 = AVCC) at 3.0 to 3.6 V, or 4.0 to 5.5 V is supplied from the user
system.
• The state of power supply can be monitored through the test pins (TP1 for VCC
and TP2 for GND).
• The state of analog power supply can be monitored through the test pins (TP3 for
AVCC0, TP4 for VREFH0, TP5 for AVCC, and TP6 for VREF).
• This clock signal at 8 to 12.5 MHz is supplied from the user system.
) that doesn't enter the state of power on reset.
POR
UVCC
R17
2. Indicated pin numbers are for pins of the YQSOCKET064SDF (CN2).
MCU（IC1）
R14
RES#
User's Manual
YQSOCEKT064SDF (CN2)
0 Ω
Pin 6
2
(RES#)*
Page 3 of 8