Renesas R0E5562GAPFK10 User Manual page 4

R0E5562GAPFK10
5. Connection
To connect this product and user system, follow the
procedure below.
This Product(R0E5562GAPFK10) can be used for
debugging and on-board evaluation in common by
mounting the NQPACK064SD-ND on the user system.
(1) For debugging
1. Mount the NQPACK064SD-ND on the user system.
Be sure to check that the location of pin 1 is correct.
2. Install the YQPACK064SD after checking for a match
with the position of pin 1 for the NQPACK064SD-ND.
Then use the YQ-GUIDE-S1 to affix the
YQPACK064SD to the NQPACK064SD-ND.
● Do NOT use the screws included with the
YQPACK064SD for fixing the YQPACK064SD.
● Do NOT use the screwdriver included with the
NQPACK064SD-ND for fixing the
YQ-GUIDE-S1. That is used only for the
HQPACK064SD. Note that you need to provide
your own screwdriver.
3. Connect this product after checking for a match with the
position of pin 1 for the YQPACK064SD.
4. Install the connector of the flexible cable from the
emulator to the 38-pin connector on this product.
Hold this product while connecting the cable to avoid
imposing heavy pressure on the 38-pin connector of this
product.
(2) For on-board evaluation
5. Mount an MCU with on-chip flash memory and the
HQPACK064SD (not included) in order on the
NQPACK064SD-ND on the user system.
Before using this product, be sure to read section 7, Notes on Usage.
Warning to Connection:
•
Always switch OFF the emulator, this product, and user system before connecting or disconnecting the
emulator. Failure to do so will create a FIRE HAZARD and will damage the emulator, this product, and
user system.
•
Make sure that the connectors on both ends of the user-system interface cable are facing the right way
relative to the user-side connector on the emulator and the 38-pin connector on this product,
respectively. Incorrect connection will create a FIRE HAZARD and will damage the emulator, this
product, and user system.
Caution to Mount the NQPACK:
•
Check the locations of pin 1 before mounting the NQPACK.
•
The tightening torque must be no greater than 0.054 N•m. If the applied torque is not accurately
measurable, stop tightening when the force required to turn the screw (YQ-GUIDE-S1) becomes
significantly greater than that required at the start of tightening. Tightening a screw too much may break
the screw hole of the NQPACK or lead to a faulty connection by cracking solder on the NQPACK side.
•
Failure of conduction during operation may be due to a crack in the solder for the NQPACK. Check
conduction with a tester and re-solder the NQPACK as required.
R20UT2114EJ0100 Rev.1.00
Sep 05, 2012
Figure 3 Connection of the User System and the MCU
Board
WARINIG
CAUTION
User's Manual
Page 4 of 8