Advertisement
Quick Links
R0E510Y16LVB00
Low voltage OCD Board for RL78/G10 Groups
1. Overview
R0E510Y16LVB00 is a debug board for R5F10Y16ASP, R5F10Y14ASP in RL78/G10 groups, which is enabled to effective debug
of hardware and software on low voltage user system.
This product is used with E1 emulator. And a box connector of 2.45mm pitch is needed to connecting user system.
Also refer to E1/E20 Emulator Additional Document for User's Manual (Notes on Connecting RL78), when you use this product.
Host machine
USB interface cable
E1 emulator
2. Specifications
Table 1 shows the functional specifications of this product.
Item
Target MCU
Support Emulator
Target I/F
Power supply for this product
Operating voltage
Operating temperature
Storage temperature
Dimensions
Weight
Note* If the user system power supply is turned on be before starting debugger, this product uses 150mA current
from user system.
R20UT2451EJ0100 Rev.1.00
Dec 20, 2012
User interface cable
* Do not mount target device on user system.
If target device is mounted, the signals are shorted
between this product and target device on user system.
Figure 1
System Configuration
Table 1
Specifications of this product
R5F10Y16ASP, R5F10Y14ASP
E1 emulator (E20 emulator is not supported )
8510-4500 : 10-pin type connecter, Sumitomo 3M Limited
Emulator or Target system*
2.0V to 5.0V
5 to 35
(No condensation)
°C
-15 to 60
(No condensation)
°C
60mm * 60mm (Does not include projection) Refer to figure2.
16g
RE510Y16LVB00
User system
Specification
User's Manual
R20UT2451EJ0100
Rev.1.00
Dec 20, 2012
Page 1 of 7
Advertisement
Related Manuals for Renesas R0E510Y16LVB00
Summary of Contents for Renesas R0E510Y16LVB00
- Page 1 Low voltage OCD Board for RL78/G10 Groups 1. Overview R0E510Y16LVB00 is a debug board for R5F10Y16ASP, R5F10Y14ASP in RL78/G10 groups, which is enabled to effective debug of hardware and software on low voltage user system. This product is used with E1 emulator. And a box connector of 2.45mm pitch is needed to connecting user system.
-
Page 2: Internal Circuit
R0E510YLVB00 User's Manual 3. Dimensions of This Product Figure 2 Dimensions of this product (R0E510YLVB00) 4. Internal Circuit To the emulator To the emulator Connector for the user TVDD system (CN2) TVDD R5F10Y16ASP 100KΩ VDD(5pin) NC7SZ66P5X 10uF 0.1uF P40(1pin) NC7SZ66P5X Short pad (Default is short) P125/RESET(2pin) - Page 3 100k ohm. P125/RESET Output P137 Output Input / Output Input / Output Input / Output Input / Output Input / Output Note* As seen from this product (R0E510Y16LVB00） R20UT2451EJ0100 Rev.1.00 Page 3 of 7 Dec 20, 2012...
-
Page 4: Use Procedure
R0E510YLVB00 User's Manual 6. Use procedure Use this product (R0E510Y16LVB00) by the following procedure. Connecting this product with emulator. Connect CN1 of this product with user interface connector of E1 emulator using 14-pin user interface cable. ↓ Connecting this product with user system Connect CN2 of this product with user system. -
Page 5: Notes On Usage
P40 is not connected microcontroller for debug on this product. It is not possible to debug of P40 port function in this product. Note on the Flash Programming Software Products (Renesas Flash Programmer, etc.): Do not use the flash programming software products for this product. - Page 6 WEEE must be treated, recycled and disposed of in an environmentally sound manner. Renesas Electronics Europe GmbH can take back end of life equipment, register for this service at http://www.renesas.eu/weee...
-
Page 7: Sales Offices
10. It is the responsibility of the buyer or distributor of Renesas Electronics products, who distributes, disposes of, or otherwise places the product with a third party, to notify such third party in advance of the contents and conditions set forth in this document, Renesas Electronics assumes no responsibility for any losses incurred by you or third parties as a result of unauthorized use of Renesas Electronics products.