Table of Contents
Advertisement
Crease-removal function
en
ÿ will appear on the display.
4.
If ÿ does not appear on the
Note:
display, the water tank is already
filled with the correct amount of
water and the program will start.
Pull out the condensation container
5.
horizontally.
Use the water jug provided to pour
6.
approx. 180 ml cold drinking water
into the filling hole in the front of the
appliance, until ÿ goes out on the
display and an audible signal
sounds.
If you pour more than 180 ml
Note:
drinking water into the appliance and
ÿ does not go out on the display,
this means that the drinking water
has been poured into the wrong
filling hole or the appliance is not
fully level. Pour the drinking water
into the filling hole on the front or
make the appliance level.
~ "Installing the appliance"
on page 13
44
Push the condensation container
7.
back into the appliance until you feel
it lock into place.
Press inicio pausa+carga ‹ (Start/
8.
Pause).
Programs for removing
creases
Do not run crease-removal programs
■
without a load in the drum. Comply
with the washing instructions on the
clothing label and do not exceed the
maximum permitted load for the
crease-removal
programs.~ Page 23
Opening the door during a crease-
■
removal program pauses the
program. To resume the program,
close the door and press inicio
pausa+carga ‹ (Start/Pause).
Crease-removal programs run for
■
approx. 45 minutes on average.
They may run for longer at low
ambient temperatures; at high
ambient temperatures, the run time
may be reduced.
There may be some extra noise
■
when a crease-removal program is
running.
Advertisement
Table of Contents
