Table of Contents
Advertisement
Help with the appliance
en
3
Help with the appliance
H e l p w i t h t h e a p p l i a n c e
Faults
Appliance does not start.
The appliance does not
respond to inputs and the dis-
play shows: ç '‚§
Creasing.
Water is leaking out.
The appliance is paused but the
drum is turning.
The programme does not start Make sure that:
Programme duration displayed
changes as drying progresses.
60
Cause/Remedy
Check the mains plug and the fuses.
If there is fluff or debris in the fluff filter or if the fluff filter is damp,
■
this may impair the airflow in the appliance at low ambient tempera-
tures.
– Clean the base unit and dry the fluff filter thoroughly.
~ Page 49
– Switch the appliance off and on again.
– Press inicio pausa+carga ‹ (Start/Pause) to restart the pro-
gramme.
Load exceeded or incorrect programme selected for a type of fabric.
■
All the required information can be found in the programme
table.~ Page 23
Remove laundry from the drum as soon as the drying programme
■
has finished. Creasing occurs when clothing is left in the drum.
The appliance may be positioned at an angle. Level the appliance.
■
In the base unit, make sure that:
■
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
~ Page 49
If the optional drain hose* is installed, make sure that the drain hose
■
is correctly connected. ~ Page 46
The appliance has detected a high temperature and has started the
CoolDown process. Temperature regulation can take up to 10 minutes.
You can cancel the CoolDown process at any time by opening the door.
The door is closed
■
The w 3 s. (Child Lock 3 sec.) has been deactivated
■
You have pressed inicio pausa+carga ‹ (Start/Pause)
■
Note:
If the programme has been delayed by setting
M termin.B N (Ready in), the programme starts at a later point.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
Advertisement
Table of Contents
