Programs For Removing Creases - Siemens WT4HXEP9DN Installation And Operating Instructions Manual

Crease-removal function
en
4. Refresher-container is empty,
please re-fill. will appear on the
display.
If Refresher-container is
Note:
empty, please re-fill. does not
appear on the display, the water tank
is already filled with the correct
amount of water and the program
will start.
Pull out the condensation container
5.
horizontally.
Use the water jug provided to pour
6.
approx. 180 ml cold drinking water
into the filling hole in the front of the
appliance, until Refresher-container
is empty, please re-fill. goes out on
the display and an audible signal
sounds.
If you pour more than 180 ml
Note:
drinking water into the appliance and
Refresher-container is empty,
please re-fill. does not go out on the
display, this means that the drinking
water has been poured into the
wrong filling hole or the appliance is
not fully level. Pour the drinking
water into the filling hole on the front
or make the appliance level.
~ "Installing the appliance"
on page 14
48
Push the condensation container
7.
back into the appliance until you feel
it lock into place.
Press ‹ (Start/Pause).
8.
Programs for removing
creases
Do not run crease-removal programs
■
without a load in the drum. Comply
with the washing instructions on the
clothing label and do not exceed the
maximum permitted load for the
crease-removal
programs.~ Page 27
Opening the door during a crease-
■
removal program pauses the
program. To resume the program,
close the door and press ‹ (Start/
Pause).
Crease-removal programs run for
■
approx. 45 minutes on average.
They may run for longer at low
ambient temperatures; at high
ambient temperatures, the run time
may be reduced.
There may be some extra noise
■
when a crease-removal program is
running.
Crease removal results may vary
■
depending on the type of fabric, the
amount of laundry and the selected
program. For best results, take the
laundry out of the machine as soon
as the program comes to an end,
hang it on a clothes hanger to finish
drying and reshape it while still
damp.