Table of Contents
Advertisement
Crease-removal function
en
Press Start/Reload .
8.
Programs for removing
creases
Do not run crease-removal programs
■
without a load in the drum. Comply
with the washing instructions on the
clothing label and do not exceed the
maximum permitted load for the
crease-removal
programs.~ Page 22
Opening the door during a crease-
■
removal program pauses the
program. To resume the program,
close the door and press Start/
Reload .
Crease-removal programs run for
■
approx. 45 minutes on average.
They may run for longer at low
ambient temperatures; at high
ambient temperatures, the run time
may be reduced.
There may be some extra noise
■
when a crease-removal program is
running.
Crease removal results may vary
■
depending on the type of fabric, the
amount of laundry and the selected
program. For best results, take the
laundry out of the machine as soon
as the program comes to an end,
hang it on a clothes hanger to finish
drying and reshape it while still
damp.
42
Cleaning the filter in the water
tank
The filter in the water tank protects the
appliance from dirt and debris and
should be cleaned regularly.
Caution!
Risk of material damage and damage
to the appliance
If you operate the appliance without a
filter or if the filter is defective, this may
result in damage to the appliance.
Always ensure that the filter is in place
and is undamaged before operating the
appliance.
Pull out the condensation container
1.
horizontally.
Remove the filter and clean it under
2.
running water or in the dishwasher.
Insert the filter into the water tank.
3.
Push the condensation container
4.
back into the appliance until you feel
it lock into place.
Advertisement
Table of Contents
