Table of Contents
Advertisement
0
Settings
Programme
setting
Note:
Not all settings can be activated in every programme. The activated settings are displayed on the but-
tons or highlighted brightly in the display. You can change or deactivate the activated settings by repeatedly
pressing on the relevant buttons on the display.
} (Remote Start)
ü tipo secado
(Drying Target):
Ò Cupboard Dry
Plus
» Cupboard Dry
Ø Iron Dry
ajuste secado
(Drying level)
M termin. B N
(Ready in)
M termin. B N
(Ready in)
Function
Pressing } (Remote Start) allows you to start the appliance remotely via the
Home Connect app or to call up the Home Connect settings.
Notes
Please observe the instructions for the ambient temperatures ~ Page 65.
■
Remote start can only be activated if the appliance door is closed and the appli-
■
ance is connected to your home network.
Remote start is deactivated for safety reasons in the following circumstances:
■
Open the door,
■
Power failure,
■
Press inicio pausa+carga ‹ (Start/Pause) on the appliance,
■
Briefly press } again,
■
Press # to switch off the appliance.
■
The dryness level defines how damp or dry the laundry is after the programme ends.
If you have set a dryness level, this is retained even after the appliance has been
switched off for the relevant programme. Exception: The settings are not saved for
Cottons.
Multi-layered, thick laundry that does not dry readily.
Normal, single-layered laundry.
Normal, single-layered laundry that still needs to be damp after drying and is suitable
for ironing or hanging up.
If you think the laundry is still too damp when the drying programme has ended, you
can adjust the degree of dryness to achieve a particular dryness level. To increase the
dryness level, set the degree of dryness to between Ô and ÔÔÔ. This extends the
programme duration but the temperature remains the same.
Once you have adjusted the degree of dryness for a dryness level, this setting is
retained even after the appliance is switched off.
Before starting the programme, you can delay the time at which the programme
ends by up to 24 hours using M and N.
The set time in hours, e.g. 8 h, is shown in the display and counts down until the pro-
gramme starts. Once the programme has started, the programme duration is dis-
played.
Note:
Observe the information about the ambient temperatures ~ Page 65.
The drying time for û timed programmes can be extended in 10-minute incre-
ments using M and N.
Overview of programmes
en
25
Advertisement
Table of Contents
