Advertisement
Next, feed the sensor wire out of your sauna in order to connect to the power unit.
Secure the wiring to the circuit board mini-terminal. Starting on the outside and moving in, the wires should connect in the
following order: blue - white - red - yellow.
Temperature Sensor
Touchpad data cable
Touchpad
The touchpad should be mounted indoors in a dry location, preferably in your
home. Once you've determined this location, use a flathead screwdriver to gently
pry the screen of the touchpad from the mounting bracket. Feed the data cable
through the hole in the mounting bracket, and mount the bracket to the location
you selected. Push the data cable connector into the port on the back of the screen
and snap the screen back into the bracket.
Next, connect the other cable to the port closest to the power unit's mini-terminal
block that is connected to the temperature sensor. Replace the power unit's cover
and turn the power switch to the on position.
PLACING THE STONES
Rinse your sauna stones to prepare them for placement. Beginning between the back wall and back heating element, place the
smaller stones in between and around the three heating elements being sure that the heating elements stay in their original
vertical position and do not touch each other. The stones should touch the elements, but not bend them. Reserve the
larger stones for placement on top of the heating elements, covering them completely. Replace the stone guard you removed at
the beginning of the heater installation.
Note: Packing stones in too tightly will restrict airflow and affect the efficiency of your heater. Loosely position the stones around
and above the heating elements. It is common to have 5-10 stones left over.
|
KIPW HEATER INSTALLATION MANUAL
PAGE 7
Advertisement
