Advertisement
Note: It is possible you will receive two temperature sensors - one in the heater box and one in the Xenio control box. They are the same
sensor - set one aside as a spare for possible later use.
Temperature sensor
Power Unit
Touchpad
The KIP heater is a wall mounted unit. Position the heater in the designated heater location in your sauna according to the
instructions below.
Remove the hardware bag from the baggie with the safety placards (2), selecting the two longer lag screws (1.5"). You will secure
these into the sauna wall so that ¼"of the screw protrudes from the wall
a. For barrel saunas, the 1 1/2"lag screws should be mounted approximately 20"off the lowest point of the barrel and spaced 15
1/4" apart and centered above the vent holes. Note: The heater will conceal a portion of the LED light. This is normal.
15 1/4
"
20
"
b. For indoor saunas, the screws should be mounted 20" off the floor, and spaced 15 1/4" apart approximately centered above the
vent holes (if present). It is fine that the heater is covering the holes as ventilation still occurs.
15 1/4
"
20
"
|
KIPW HEATER INSTALLATION MANUAL
PAGE 3
Advertisement
