Advertisement
Hang the heater on the mounting screws to ensure it is level and that its base sits 5-7"off the floor of the sauna.
If these criteria are met, make a mark on the wall of the sauna directly behind one of the rubber gaskets on the lower back of the
heater; this will be where the power enters the sauna. Take the heater off the wall and remove the rubber gasket, exposing the
cutout. It does not matter which gasket is removed.
NOTE: While this location is the most common, the power can enter the sauna at any location. It is not recommended you use the pre-
drilled vent holes as an entrance for the conduit.
Remove the two screws holding the stone guard in place. Pry the guard back and lift up to remove it. Clip the ziptie holding the
heating elements in place being sure the tie doesn't fall into the heater.
Flip the heater on its back and remove the bottom cover so your electrician can gain access to the terminal block.
|
KIPW HEATER INSTALLATION MANUAL
PAGE 4
Advertisement
