Lighting Does Not Work; Problems With The Tyres; Problems With The Seat Post - Bosch Premio EVO Translation Of Original Operating Instructions

9.2.11 Lighting does not work

Symptom Cause
The front light or rear light
The default settings in the electric drive
does not go on, even
system have probably been configured
when the switch is
incorrectly. The light is defective.
pressed.
Table 82: Lighting error solution

9.2.12 Problems with the tyres

Symptom Cause
Presta valve used with a sizeable valve
Valve torn off. hole. The hole's metal edge separates
the valve stem from the tube.
Table 83: Fault solution for tyres

9.2.13 Problems with the seat post

Symptom Cause
Seat post clicks or creaks. Protective layer missing.
Seat post deflects and Incorrect preload.
bobs periodically.
Seat post with remote
Bowden cable is not tensioned
control does not rise or
correctly.
lower.
Table 84: Fault solution for the seat post
MY23P0a - 42_1.0_19.10.2022
Troubleshooting, fault clearance and repair
Remedy
1 Take pedelec out of service immediately.
2 Contact specialist dealer.
Remedy
 Contact specialist dealer. Fit another type of valve.
Remedy
 Maintain seat post (see Section 7.4.9).
 Adjust preload so that the suspension seat post does not
compress under the rider's weight when at rest.
 Adjust the Bowden cable with the setting screw (1) on the
remote control.
1
Figure 225: Remote control with setting screw (1)
• Reduce sensitivity: turn the setting screw clockwise.
• Increase sensitivity: turn setting screw anti-clockwise.
261