Table of Contents
Advertisement
2 Installation procedures
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
555-4001-110 Standard 09.03 July, 2002
After connecting handset cord to the connector in the base of the
telephone, turn smooth side of handset cord up (away from
telephone base) before tucking it under the restraining tab.
Response: This ensures that the telephone sits level on the
desk after installation is complete. See Figure 1.
If: You are installing the M2009 or M2018,
Then: Perform Steps 5-8 and Steps 14-22. Otherwise, go to
Step 9.
Connect the line cord to telephone base.
Response: See Figure 1.
Tuck the line cord under the four restraining tabs.
Response: This allows the telephone to sit level on the desk.
Insert line cord into wall jack.
Response: The TELADAPT connectors have a latch-tab, which
ensures correct alignment and prevents the cord from being
pulled out inadvertently during service.
Ensure that this latch-tab is firmly snapped into place.
If: You are installing the M2112,
Then: Perform Steps 9 -22.
Connect the 6-conductor line cord to the telephone base.
Response: See Figure 1.
Tuck the line cord under the four restraining tabs.
Response: This allows the telephone to sit level on the desk.
Insert connecting block into wall jack.
Insert line cord into connecting block.
Response: The TELADAPT connectors have a latch-tab, which
ensures correct alignment and prevents the cord from being
pulled out inadvertently during service.
Ensure that this latch-tab is firmly snapped into place.
Plug electrical cord into auxiliary power supply.
Turn telephone right side up, and place in final position.
Print directory number on designation card.
Remove number lens by inserting the end of a paper clip into the
hole at the middle of the lens and levering upwards.
Insert designation card.
Advertisement
Table of Contents
