Bridge Normal Mode Led Indications - Cisco Aironet 1400 Series Installation Manual

Checking the LED Indicators
Table 5-2
Signal Level (dBm)
-75 to -72
< -75
When using LEDs to maximize the signal, you adjust the antenna until as many LEDs as possible are
turned-on and the rest are blinking as fast as possible. With all three LEDS turned-on, the signal is good
enough to support the maximum data rate.

Bridge Normal Mode LED Indications

During normal operation the bridge LEDs provide status information as shown in
Table 5-3
Ethernet
Indicator
Off
Green
Blinking
green
Blinking
amber
amber
-
-
-
-
Red
-
-
-
-
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
5-4
D R A F T - C I S C O C O N F I D E N T I A L
LED Installation Mode Signal Strength Display (continued)
Ethernet LED
Off
Off
Bridge Normal Mode LED Indications
Status Radio
Indicator Indicator
- -
- -
- -
- -
- -
Blinking -
green
Green -
Blinking -
amber
Amber -
Amber Red
- Off
- Blinking
green
- Blinking
amber
- Amber
Status LED Radio LED
Off Slow blink
Off Off
Meaning
Ethernet link is down or disabled
Ethernet link is operational
Transmitting and receiving Ethernet packets
Transmitting and receiving Ethernet errors
Firmware error—You should disconnect and reconnect the
power injector power jack
Root mode—no remote bridges are associated
Non-root mode—not associated to the root bridge
You should check the SSID and security settings of all
bridges
Root mode—associated to at least one remote bridge
Non-root mode—associated to the root bridge
Normal operation
General warning
Loading firmware
Loading Firmware error—You should disconnect and
reconnect the power injector power
Normal operation
Transmitting and receiving radio packets
Maximum retries or buffer full occurred on the radio
interface
Radio firmware error—You should disconnect and
reconnect power injector power
Chapter 5 Troubleshooting
Table 5-3.
OL-4072-01