Installation Summary - Cisco Aironet 1400 Series Installation Manual

Installation Summary

Figure 2-4
1
3
Figure 2-5
1 and 2

Installation Summary

During the installation of the bridge, you will perform the following operations:
•
•
Tip
•
•
•
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
2-8
D R A F T - C I S C O C O N F I D E N T I A L
Power Module
1
48 VDC power output cable
AC power cord
Grounding Block
1 2
F-type coaxial connectors
Connect a user supplied CAT5 Ethernet cable from your wired LAN network to the power injector.
Connect the dual-coax Ethernet cables between the power injector and the grounding block
You can connect the dual coax cable connectors to either of the grounding block connectors or
the power injector's Ethernet ports. The bridge senses the Ethernet signals and automatically
switches internal circuitry to match the cable connections.
Connect a ground wire to the grounding block.
Mount the bridge to the external tower or mast. For additional information, refer to the Cisco Aironet
Series 1400 Wireless Bridge Mounting Instructions that shipped with your bridge.
Connect a ground wire to the bridge (use the bridge ground lug)
3
2
2
Power module
3
3
Ground wire lug
Chapter 2 Installation Overview
OL-4072-01