Set Fire Source Shielded Region - HIKVISION DS-2TD6267-100C4L/WY User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Note
The settings vary according to different models.
6. Optional: you can shield certain areas from being detected in fire source detection. Refer to Set
Fire Source Shielded Region for details.
7. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for
setting linkage method.
8. Click Save.

4.5.1 Set Fire Source Shielded Region

Steps
1. Go to Configuration → Local, and enable Display Shield Area.
2. Go to Configuration → Event → Smart Event → Fire Source Region Shield.
3. Check Enable Fire Source Detection Shield .
4. Select Drawing Mode, and draw the area you want to shield.
In FOV
Out FOV
In Panorama Map
Select this mode if the shielded area is in the current scene.
1. Click the PTZ control buttons to find the area you want to shield
from the fire detection.
2. Click Draw Area, and drag the mouse in the live view to draw the
area.
3. You can drag the corners of the red rectangle area to change its
shape and size.
4. Click Stop Drawing to finish drawing, or click Clear All to clear all
of the areas you set without saving them.
Select this mode if the shielded area exceeds the current scene.
1. Click Draw Area, and a red cursor displays in live view.
2. Select Vertex NO. 1, and adjust the live view image by clicking the
PTZ control buttons.
3. When one corner of the shielded area is on the red cursor, click
Set Vertex.
4. Repeat steps b-c to set other three vertexes.
5. Click Stop Drawing to finish drawing, or click Clear All to clear all
of the vertexes you set.
Select this mode if you want to view the whole scene.
1. Click Draw Area and drag the mouse in the live video window to
draw the area.
2. Drag the corners of the red rectangle area to change its shape and
20