Set Fire Detection Parameters - HIKVISION DS-2TD6267-100C4L/WY User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
15
15
km
10
10
km
5 km 7
3 to
5
5 km

4.5 Set Fire Detection Parameters

To avoid the potential fire damage, you should configure the fire detection function for certain
areas. The detail configuration steps show as below.
Before You Start
● The fire detection function can locate the fire source area quickly together with patrol or linear
scan. Please refer to Set Patrol Scan for configuring patrol. Please refer to Set the Presets for
presets setting.
● Please refer to Set Device Position for locating the fire source position.
● Go to Configuration → Local, set the fire point parameters.
Locate Highest Temperature Point
Click and save to show the position of the highest temperature on the interface.
Frame Fire Point
Click and save to frame the detected fire source.
●
Steps
1. Go to Configuration → Event → Smart Event, select Fire and Smoke Detection.
2. Check Enable Fire and Smoke Detection.
3. Refer to Detection Mode and Application Scene for setting the fire detection mode.
4. Check Display Fire Source Frame on Stream to display a red frame around the fire source on
stream when fire occurs.
5. Setting the parameters of fire detection.
Detection Mode
by Single Frame
It can quickly detect fire while moving, but have a high false positive rate.
Adjust Sensitivity during Patrol. The bigger the value is, the more easily the fire source can
4 20 4
5 15 4
6 10 5
6 7 6
/ / /
12 4 /
8 5 20
6 6 13
18
/ / /
/ / /
4 13 4
4 9 5
/ /
/ /
/ /
15 4