Revo GPE036W-A180200-Z Operating Instructions Manual page 71

System settings
Setup wizard
Press the MENU button and then select [Main Menu > System Settings > Setup wizard].
>
When the device is switched on for the first time, the setup wizard starts automatically.
> When the display shows [Start now?], select [YES].
If you select [No], the wizard will exit and you will have to apply the necessary settings manually
You will now be guided through the settings step by step.
Select the desired display format for the time display under [Time Format]. (For more details see chapter
>
"Time settings")
> In the next step, you must select which source is to be used to synchronise the time. (For more details see chapter
"Time settings")
Once you have selected [Update form Net], you must then specify the time zone and the summer/winter
time.
After the time and date settings, some network settings are
now applied.
Select whether the WiFi connection should also remain active in standby. press the SELECT button.
>
> Make sure that the device is within range of the desired WiFi network and that you have the access details. In some
cases it may be necessary to apply some settings on the router. In this case, please consult the relevant operating
instructions.
After a search for available wireless networks, you will be shown the result.
Select the desired wireless network and confirm the selection with SELECT.
>
Select Skip WPS to enter the password.
If it is a protected network, you will be prompted to enter the corresponding access key
> To do this, mark the corresponding character in each case.
> Then enter the selected character by pressing the SELECT button.
Continue moving in this way until the complete access key is visible in the input field.
To cancel the entry, select
pressing
> Then select
network is now established.
When [Setup Wizard Completed] appears in the display, press the SELECT button.
>
Info
Press the MENU button and then select [Main Menu > System Settings >Info].
>
Confirm by pressing SELECT.
>
> The software version is displayed.
Press the MENU button to switch back.
>
and press SELECT. If you make a mistake, you can delete the last letter entered by
.
and press the SELECT button. If the password was correct, a connection to this
.
.
71