Revo GPE036W-A180200-Z Operating Instructions Manual page 68

System settings
Internet settings
Press the MENU button and then select [Main Menu System Settings > Network].
In this menu you will find some settings and information about the internet connection.
Select Network Wizard to establish a WiFi connection.
The network wizard shows you all WiFi stations within range.
Select the WiFi network you know using / and SELECT, and enter the corresponding password using the
>
displayed keypad.
> Then select
established.
You can see if there is a connection by the signal bars
To cancel, select
.
> If you want to establish a WPS connection instead of entering the password, proceed as follows after selecting the WiFi
network:
For information on how to activate WPS on your router, please refer to its operating instructions.
Select [Press button] on the SUPERCONNECT STEREO after selecting the WiFi network.
>
Follow the instructions on the display.
> Start WPS on your router by pressing the corresponding button.
If your router only supports the WPS PIN, select [PIN] on the SUPERCONNECT STEREO and write down the PIN shown on the
>
display. You must then enter the PIN in the router.
WPS connection
Select [Internet Settings > PBC WLAN Setup] if your router has the WPS function.
>
This establishes a direct connection to the router without having to enter the WiFi password.
For information on how to activate WPS on your router, please refer to its operating instructions.
> Start WPS on your router by pressing the corresponding button.
68
and press the SELECT button. If the password was correct, a connection to this network is now
and press the SELECT button. If you make a mistake, you can delete the last letter entered by pressing
in the status bar of the display.