General Operation; Switching On The Device; Operating The Device; Setting The Volume - Revo GPE036W-A180200-Z Operating Instructions Manual

General operation

Switching on the device

By pressing the
>
standby.
After switching on for the first time, you can start the setup wizard. Here you can set the date and time either via DAB/
FM, Internet or no update (manual). An attempt is then made to establish a connection to a WiFi network. To do this, select the
corresponding WiFi network and, if necessary, enter the WiFI password with the remote control.
Switching off the device
By pressing the
>
The date and time appear in the display.
Operating the device with the remote control
With the infrared remote control, you can operate the most important functions of the device from the comfort of your chair. When
operating the device with the remote control, please observe the following points:
> Point the remote control at the front of the device.
> There must be a of sight between transmitter and receiver.
> If the range of the remote control decreases, the batteries should be replaced with new ones.
The maximum range is approximately 5 metres within an area in front of the device.

Setting the volume

Adjust the volume with the VOL+/VOL- (12/2) buttons on the remote control or the knob on the device.
>
The volume set is shown in the display.

Muting the sound

> You can turn off the sound by pressing the MUTE (8) button on the remote control.
This mode is signalled in the status bar by a corresponding icon.
Pressing the MUTE button again turns the sound back on.
>

Open displays

Pressing INFO on the device or INFO (17) on the remote control several times while playing a source
>
allows you to display and cycle through more information.
52

Display

button on the device or on the remote control, you can switch the device on or switch it back to
button on the device or on the remote control, you can switch the device to standby.