Expansion Slots - PCchips M830LU User Manual

Mainboard User's Manual
Infrared Port
You can connect an infrared port to the mainboard. You can
purchase this option from third-party vendors.
1. Locate the infrared port IR header on the mainboard.
2. If you are adding an infrared port, connect the ribbon cable
from the port to the IR header and then secure the port to an
appropriate place in your system chassis.
Pin Signal
1 NC
3 +5V
5 IRTX
Onboard LAN LED Connections
If you have a set indicator LEDs for the onboard LAN
communication, you can connect the LED cable to the header JP2.
Pins 1-2 are for Link LED. Pins 3-4 are for 10/100 Mbps mode
LED, the onboard LAN run in 100 Mbps mode when the LED lit.
Pin Signal
1 Link LED
3 GND

Expansion Slots

This mainboard has five 32-bit PCI slots, one AGP slot and one
AMR slot.
PCI5
PCI3
PCI1
AGP1
PCI4 PCI2
Follow the steps below to install a PCI/AGP/AMR expansion card.
1. Locate the AMR, AGP or PCI slots on the mainboard.
2. Remove the slot cover for this slot from the system chassis.
16
Pin Signal
2 KEY
4 GND
6 IRRX
Pin Signal
2 VCC
4 10/100 Mbps mode LED
AMR1