Figure 2-2: Mediant 2000 Rear Connectors (16 Trunks, Ac Power); Table 2-1: Mediant 2000 Cables And Cabling Procedures - AudioCodes Mediant 2000 Installation Manual

Fast Track Installation Guide

Figure 2-2: Mediant 2000 Rear Connectors (16 trunks, AC power)

Two
Ethernet
RJ-45 ports

Table 2-1: Mediant 2000 Cables and Cabling Procedures

Cable
Connect the 10/100 Base-T RJ-45 ETHERNET port directly to the PC
network port with a crossed Ethernet cable (when changing the IP
10/100 Base-T
address). After changing the IP address, connect both ports to the IP
Ethernet cable
network, using standard Ethernet cables. One port is for redundancy.
Customers assembling the 50-pin Telco cable connector must wire it
according to the pinout in Figure 2-4 and Table 2-2 on page 10. Attach
50-pin Telco
the (male) Telco cable connector to the 50-pin (female) connector on
cable
the Rear Transition Module (RTM). Connect the other end to the
PBX/PSTN switch.
Permanently connect the device to a suitable ground with the
Grounding
grounding screw on the rear connector panel, using 14-16 AWG wire.
Connect the 100-240V~50-60 Hz power socket to the mains using the
Power cable
supplied cord (with the single AC power supply version of the device).
(for single AC)
Connect each of the dual 100-240V~50-60 Hz power sockets to
Two power
separate mains circuits (for power source redundancy) using the two
cables (for dual
supplied cords (with the dual AC power supply version of the device)
AC)
Connect the wire's 2-pin female to its mating on the terminal block. The
DC version is equipped with a -48 VDC (floating) inlet. Use #14-16
DC power cord
AWG cables for the DC connection.
To cable the Mediant 2000, take the following 6 steps:
Connect the power supply using either the IEC32 connector cable (supplied)
1.
for the AC version (refer to Figure 2-2 and Figure 2-3) or the 2-pin connector
for the DC version (refer to to Figure 2-5).
Version 4.2
Two 50-pin
Telco female
connectors
Cabling Procedure
9
Installing the Mediant 2000
Grounding Dual IEC320
screw type inlets
February 2004