CeraGem MASTER V6 User Manual page 20

3. Using the remote control
Using the semi-automatic mode
* In Semi-automatic mode, the internal projector will not move to
the cervical spine after the mode ends.
1. Turn on the remote control, check the current status
and press the semi-automatic mode button.
2. Specify the target area for massage by holding down
either the up/down buttons until the desired position
is found.
3. The semi-automatic mode will begin at the chosen
location. Remain in the proper body postion.
- The remaining time is displayed at the upper left corner of the screen.
- If the remote control is operated while in use, the remaining time is reset.
- When 60 minutes have passed after operating the remote control,
the remote control will turn off automatically and the mode will end.
- When pausing, the internal projector will move down vertically in order to
prevent burns and injury.
(When the mode is executed again, the set strength will be restored.)
- When 5 minutes have passed after pausing, the product will turn off automatically.
36
Approximately
Duration of mode
60 minutes
3. Using the remote control
Using the semi-automatic (master) mode
* In Semi-automatic master mode, the internal projector will not move to
the cervical spine after the mode ends.
1. Turn on the remote control, check the current status
and press the semi-automatic mode button twice.
2. Move the internal projector to the desired position
using the up/down button.
- The selected position will be displayed in green.
Position
Neck area
(cervical spine)
Back area
(thoracic vertebrae)
Waist area
(lumbar vertebrae)
3. Once scanning is complete, the semi-automatic master
mode will begin. Remain in the proper body position.
- The remaining time is displayed at the upper left corner of the screen.
- If the remote control is operated while in use, the remaining time is reset.
- When 60 minutes have passed after operating the remote control,
the remote control will turn off automatically and the mode will end.
- When pausing, the internal projector will move down vertically in order to
prevent burns and injury.
(When the mode is executed again, the set strength will be restored.)
- When 5 minutes have passed after pausing, the product will turn off automatically.
Approximately
Duration of mode
60 minutes
Screen display (24 segments)
C1~7
T1~12
L1~5
37