CeraGem MASTER V6 User Manual page 19

3. Using the remote control
Using the manual mode
1. Turn on the remote control, check the current status,
and press the manual mode button.
2. Specify the target area for massage by holding down
either the up/down buttons until the desired position
is found.
3. The manual mode will begin at the chosen location.
Remain in the proper body postion.
- The time remaining will be displayed at the top of the human body icon.
- If the remote control is operated while using the product,
the time remaining will be initialized.
- When 5 minutes have passed after setting the remote control,
the internal projector will move automatically in order to prevent burns.
- When 60 minutes have passed after setting the remote control,
the remote control will turn off automatically and the mode will end.
- When pausing, the internal projector will move down vertically in order to
prevent burns and injury.
(When the mode is executed again, the set strength will be restored.)
- When 5 minutes have passed after pausing, the product will turn off automatically.
34
Approximately
Duration of mode
60 minutes
3. Using the remote control
Using the manual (master) mode
1. Turn on the remote control, check the current status
and press the manual mode button twice.
2. Move the internal projector to the desired position
using the up/down button.
Volume 5
T1 icon - The selected position will be displayed in green.
3
55
Position
Neck area
(cervical spine)
Back area
(thoracic vertebrae)
Waist area
(lumbar vertebrae)
3. Once scanning is complete, the manual master mode
will begin. Remain in the proper body position.
- The remaining time is displayed at the upper left corner of the screen.
If the remote control is operated while in use, the remaining time is reset.
- When 5 minutes have passed after setting the position, the internal
projector will move automatically in order to prevent burns.
- When 60 minutes have passed after operating the remote control,
the remote control will turn off automatically and the mode will end.
- When pausing, the internal projector will move down vertically in order to
prevent burns and injury.
(When the mode is executed again, the set strength will be restored.)
- When 5 minutes have passed after pausing, the product will turn off automatically.
Approximately
Duration of mode
60 minutes
Screen display (24 segments)
C1~7
T1~12
L1~5
35