CeraGem MASTER V6 User Manual page 14

3. Using the remote control
Setting the internal projector speed
* When using the automatic mode, the internal projector speed will be displayed, allowing you to set the internal
projector speed. (speed setting is not available in some modes.)
1. Check the speed of the current mode.
2. Press the up/down button and set the desired speed.
- The internal projector speed can be set only from the main screen of the remote control.
3. Check the changed speed of the mode on the screen of
the remote control.
24
Low speed Constant speed High speed
3. Using the remote control
Setting the thermal sofa mode
1. When the supporting mat is closed, the device can
be operated as a thermal sofa for comfortable seating.
The "thermal sofa" icon will be displayed. When the
remote control is turned on, check the display.
2. To adjust the temperature of the thermal sofa, press
the temperature select button until the desired item is
highlighted in red, then toggle between the up/down
button to increase/decrease the temperature setting.
- When the thermal sofa mode is used, the temperature (preheating) can be adjusted.
- The abdominal vibration projector and 3-sphere projector will only be displayed when connected.
- When a temperature is selected, the image of the relevant item will be displayed in red.
Internal
projector
1
2
Off, 86~149℉
3. After setting the temperature, the current temperature
will be displayed.
- If the remote control is operated while using the product, the time
remaining will be initialized.
Low temperature burns may occur, so avoid any direct skin contact with
the abdominal vibration projector and 3-sphere projector(optional product)
and do not use the product on body parts which are less sensitive or with
Caution
poor blood circulation (around eyes, neck, armpits, backs of knees, etc.)
for a long period of time.
(the supporting mat is closed)
Abdominal vibration 3-Sphere projector
Main mat Supporting mat
projector (optional product)
Off, 86~140℉
25