Using The Remote Control - CeraGem MASTER V6 User Manual

2. Remote control layout
Screen display
8
- Main screen -
When setting
the temperature the air massage
- When the supporting mat is closed, the closed supporting mat image will be displayed as the product image.
- When 10 seconds have passed after the remote control was last operated, the screen will become dark.
(When a button is operated, the screen will become bright again.)
20
Display of speed of the internal projector
1
(low speed/constant speed/high speed)
Sound source
2
(Ceragem sound/USB/Bluetooth/Voice guidance)
3 Sound pause
4 Volume
(0-20)
5 Time remaining
(in minutes)
6
Internal projector location
Mode
7
(Automatic mode A,1-16/Intensive/Semi-automatic/Manual)
8
Strength display
(1-9)
9 Internal projector temperature
(86℉-149℉)
10 Abdominal vibration projector
When setting When setting
abdominal vibration projector

3. Using the remote control

Turning on the product
1. Check the cable and the power switch on the main body
of the product, and press the power button on the
remote control.
- To turn off the remote control, press the power button for approximately
2 seconds.
If there is any discomfort or emergency while operating the product,
press the on/off button on the remote control to stop the operation.
2. The Ceragem logo will appear on the screen of the
remote control and the remote control will turn on.
3. When the main screen is displayed, use the product
by pressing the desired button.
- The last-used set value will be displayed.
(The set value will not be stored if the product is turned off abnormally.)
- When the product is closed, the closed product image will be displayed.
- Before using the product, check if the power cord
is connected to the product and the electrical
outlet correctly.
(If the power is not turned on, refer to Page 42.)
21