Table of Contents
Advertisement
Stubborn soiling (excluding the
FlexiClip telescopic runners)
Spilled fruit and roasting juices may
cause lasting discolouration or matt
patches on enamelled surfaces. This
discolouration is permanent but will
not affect the functional
characteristics of the finish. Do not
attempt to remove these marks.
Clean them following the instructions
given here.
Baked on deposits can be removed
with a glass scraper or with a non-
abrasive stainless steel spiral pad,
warm water and washing-up liquid.
Oven cleaners will damage the
catalytic enamelled surfaces.
Remove the catalytic enamelled
panels before using an oven cleaner.
Very stubborn soiling on PerfectClean
surfaces can be cleaned using Miele
Oven Cleaner. This cleaner must only
be applied to cold surfaces. Follow
the instructions on the packaging.
Non-Miele oven cleaner must only be
used in a cold oven and not left on for
longer than a maximum of 10 minutes.
If necessary, the scouring pad on the
back of a non-scratching washing-up
sponge can be used to remove the
soiling.
After cleaning, remove all oven
cleaning agent residues thoroughly
with clean water, and dry with a soft
cloth.
Cleaning and care
Stubborn soiling on the
FlexiClip telescopic runners
Do not clean FlexiClip telescopic
runners in a dishwasher. The special
lubricant used in the telescopic
runners will wash out during
dishwashing.
In the case of stubborn soiling on the
surfaces of the telescopic runners, or
clogged bearings caused by fruit juices
spilling over, proceed as follows:
Soak the FlexiClip telescopic runners
for approx. 10 minutes in a solution of
hot water and washing-up liquid.
If necessary, use the back of a
washing-up sponge to remove the
soiling. The bearings can be carefully
cleaned with a soft brush.
The runners may appear discoloured
or a lighter colour in places after they
have been cleaned. This will not affect
the functioning of the runners in any
way.
75
Advertisement
Chapters
Table of Contents
