Driver For Rotor Exchanger - Dantherm BasX Service Manual

Driver for rotor exchanger

Description The rotor exchanger is run by a step motor with a control box. The unit is provided with
a revolution controller consisting of a magnet attached to the rotor exchanger and a
reedswithch connected to the control box (see the wiring diagram below).
The motor and the control box are placed right behind the cover plates of the module in
the same side as the control panel.
Wiring diagram This shows the wiring diagram:
Jumpers The control box PCB is fitted with 3 jumpers, J3, J2 and J1.
It is imperative, that the jumpers are set for the current operating situation
The unit is fitted with a rotation guard as standard
Rotation guard – jumper 3
Max. motor speed – jumper 2
Rotor diameter,
Model
BasX 2
BasX 4
Motor speed, RPM
mm
800 150
1050 200
Setting
ON
J2
Setting
ON
OFF
Continued overleaf
29