Table of Contents
Advertisement
Driver for rotor exchanger,
Jumpers,
continued
Jumper 1, motor
rotation
Technical data
30
Max. motor speed – jumper 2
Model
BasX 6
BasX 10
BasX 14
Direction of motor rotation for rotor exchanger – jumper 1
J1: OFF
Pos. right unit with
Pos. right unit with
fresh air inlet in the
fresh air inlet in the
bottom
top
The control box has a built-in thermal fuse preventing an overload of the electronics.
A separate type G fuse must be installed to protect the main cable.
Supply voltage:
Max. prefuse:
Voltage signal
Impedance (voltage signal)
Serial communication
Rotation guard
Supply for Hall element
Relay output for alarm
LED indication
Torque
Enclosure
continued
Rotor diameter,
Motor speed, RPM
mm
1250
1550
1950
J1: ON
Pos. left unit with
fresh air inlet in the
top
50 – 60 Hz, 230 V AC +/- 15 %
16 A
0 – 10 V DC
10 kOhm
RS485 ABC-Bus
Reed switch (also active in purging
operation)
15 V DC
(internal pull-up 1.1 kOhm resistance)
NO relay 5 A, 250 V
2-colour (green/red)
2 Nm, 4 Nm and 6 Nm
IP54
J2 Setting
150
ON
200
OFF
150
ON
J1: ON
J1: OFF
Pos. left unit with
fresh air inlet in the
bottom
Controller inputs
Controller outputs
Continued overleaf
Advertisement
Table of Contents
