Dantherm BasX Service Manual page 16

How to service the rotary heat exchanger,
Procedure,
preventive
maintenance
16
The rotary heat exchanger is serviced as described below:
Step
1 Check that the brushes are intact
2 Use a soft brush to remove dust on the edges of the rotary heat exchanger
3 Wash with fat-dissolving detergent to remove fat or dirt on the edges of the
heat exchanger
4 If necessary, clean the heat exchanger by compressed air.
Use a vacuum cleaner to remove dirt from the opposite side of the heat
exchanger
5 Check that the brushes around the rotor are undamaged and tight-fitting.
6 Check the rotor driving belt and the transmission.
continued
Action