Advertisement
STEP 11: (REAR WINDOW)
11.1 Measure the back of the rear legs, inside to inside, and
adjust the width to 24-7/8". Measure corner to corner
for squareness, and tighten the (8) sets of screws and
nuts that attach the rear legs to the ROPS, to lock in
this width. See figure 11.1
11.2 Grease the hinge pins for the rear window, and slide on
greased brass washers (one washer per pin). See
Figure 11.2.
11.3 Hang the rear window on the hinges.
11.4 Connect the window latches to the right rear leg by
depressing the tabs on the latch and inserting into the
receivers mounted on the rear leg. Close and check the
alignment of the window. If off, check measurements
and re-align the rear legs. Tighten the hinge hardware
to 7 ft.-lbs. Verify smooth operation of the latches.
STEP 12: (TIGHTEN HARDWARE)
12.1 Tighten all hardware at this time, using the torque values
given below.
Each side frame can be pushed inward at the back to
close any gaps along the fender contour before
tightening hardware.
For 5/16" bolts that thread into factory installed threaded
inserts in the side frames without plastic washers, use
20 ft.-lbs.
For 5/16" bolts that use plastic washers, use only 12.5 ft.-lbs.
For the remaining 5/16" bolts (the vast majority on the cab)
that thread into hex nuts, use 28 ft.-lbs.
For all other bolt sizes, reference the torque tables at the end
of the manual.
STEP 13: (LEFT STEP)
13.1 If equipped, re-install the left step to the new relocation
tabs on the side frame using the hardware saved
earlier. See Figure 13.1
CAB INSTALLATION
24-7/8"
Fig. 11.1 (Measure Rear Legs Left to Right)
Brass Washers
on Greased Pins
Fig. 11.2 (Hang Rear Window)
Fig. 13.1 (Install Left Step)
9 of 29
Snap Latches
into Right
Rear Leg
2 Places
Advertisement
