Advertisement
STEP 5: (REAR FLASHERS)
5.1
Attach a flasher relocation bracket to the flasher
mounting tab on the ROPS. See Figure 5.1.
Hardware Used
1/2-13 X 1 Hex Head Screw
1/2-13 Hex Nut
Tools required
3/4" wrench or socket
5.2
Slide the flasher into the slot in the flasher relocation
bracket and tighten the nut. See Figure 5.1.
5.3
Repeat steps 5.1 and 5.2 for the right rear flasher.
STEP 6: (WINDSHIELD SUPPORT)
6.1
With assistance, hold the windshield support in place
and attach with a screw to the front of each side frame.
See Figure 6.1. Do not screw in the top at this point.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
Tools required
1/2" wrench or socket
STEP 7: (COWL)
7.1
With assistance, carefully slide the cowl in place and
loosely secure with fasteners. See Figure 7.1.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
5/16-18 Hex Nut
Tools required
1/2" wrench and socket
CAB INSTALLATION
Qty
1
1
Qty
2
Qty
14
8
Fig. 5.1 (Install Rear Flashers)
5/16-18 x 3/4 Screws
Fig. 6.1 (Install Windshield Support)
5/16-18 x 3/4 Screw
Fig. 7.1 (Install Cowl)
7 of 29
5/16-18
Nut
Advertisement
