Advertisement
STEP 14: (FRONT FILLERS CONT'D)
14.4 With the left side located, the right side should end in-
line with the cutout in the cowl. See Figure 14.4. Start
securing the filler in place with Velcro while ensuring the
filler stays in place. Force the filler to follow in and out
of the channel on both sides of the console noted in
Figure 14.2 on the previous page.
14.5 Secure outside of the left side of the filler to the cowl
and floor pan. See Figure 14.5. Ensure there are no
gaps between the filler, the cowl, and the floor pan.
14.6 Slide the Right Side Filler over the brake pedal through
the pedal slit in the bottom and set into place. See
Figure 14.6. Do not secure Velcro at this time.
14.7 Slide the top right edge of the filler through the transition
slot. See Figure 14.6. Secure the top of the filler to the
left/center filler and cowl, then secure sides, followed by
the bottom along the floor pan.
CAB INSTALLATION
Match Edges
Fig. 14.4 (Secure Right Side Of Filler)
Mind Gaps
Fig. 14.5 (Outside View Of Left Side Transition)
Pedal Slit
Fig. 14.6 (Right Side Filler)
11 of 29
Transition Slot
Mind Gaps
Mind Gaps
Transition Slot
Advertisement
