Advertisement
STEP 2: (PRE-ASSEMBLE REAR LEG)
2.1
Pre-assemble the left rear leg and a ROPS mount. See
Figure 2.1.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
5/16-18 Hex Nut
Tools required
1/2" wrench and socket
2.2
Repeat step 2.1 for right rear leg.
STEP 3: (REAR LEG AND ROPS
MOUNTS)
3.1
Slide on the lower ROPS clamp (taller one) onto the
ROPS just above the flasher bracket. See Figure 3.1.
3.2
With help, attach the left rear leg assembly to the lower
ROPS clamp as well as adding an upper ROPS clamp.
Leave hardware loose at this time. See Figure 3.2.
Ensure there is a gap between the rear leg and the
fender.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
5/16-18 Hex Nut
Tools required
1/2" wrench and socket
3.3
Repeat steps 3.1 and 3.2 for right rear leg.
CAB INSTALLATION
Qty
2
2
Qty
8
8
ROPS Mount
Fig. 2.1 (Pre-Assemble ROPS Mount to Rear Leg)
Larger ROPS Clamp
Fig. 3.1 (Slide On Lower ROPS Bracket)
Fig. 3.2 (Install Left Rear Leg)
5 of 29
Smaller
ROPS
Clamp
Larger
ROPS
Clamp
Gap
Advertisement
