Advertisement
STEP 14: (FRONT FILLERS)
14.1 Pre-install the supplied Velcro to both front fillers. Leave
the release tape on until the filler is in place.
14.2 Set the left/center filler in place over the center console.
See Figure 14.2. The front of the filler should rest on
the arch on the cowl and run tight to the front face. Do
not apply the Velcro at this time. Note the channel in
the console that the filler needs to follow to seal
properly.
14.3 The left side of the filler runs along the left window, then
transitions from inside to outside the cab through the
slot. See Figures 14.3a and b. Do not apply the Velcro
at this time. The inner bottom of the filler should sit just
on top of the vehicle floor pan.
CAB INSTALLATION
Rest On Arch
Fig. 14.2 (Set Left/Center Filler Into Place)
Align With
Window
Fig. 14.3a (Left Side Of Filler)
Transition Slot
Fig. 14.3b (Inside View Of Left Side Transition)
10 of 29
Note Channel
Floor Pan
Advertisement
