Advertisement
STEP 16: (PRE-ASSEMBLE HEATER)
16.1 Remove the heater screws shown in Figure 16.1 and
reuse to attach the heater brackets to the sides of the
heater box. Tighten hardware.
Tools required
#2 Phillips Screw driver
16.2 Apply 1/4" wiring loom to the heater wires. See Figure
16.2.
STEP 17: (INSTALL HEATER)
17.1 Install the 2 supplied plastic snap bushings in the right
cab floorboard. See Figure 17.1.
17.2 Attach the heater to the cowl. See Figure 17.2.
Hardware Used
1/4-20 x 5/8" Hex Head Screw
Tools required
3/8" socket or wrench
CAB INSTALLATION
Qty
4
Reuse
Screws
Fig. 16.1 (Pre-Install Heater Brackets)
Fig. 16.2 (Apply Loom to Heater Wires)
Snap Bushings
Fig. 17.1 (Install Snap Bushings)
1/4-20
Screws
Fig. 17.2 (Install Heater)
13 of 29
Reuse
Screws
Connect and cover
1/4" Loom
1/4-20
Screws
Advertisement
