Advertisement
STEP 1: (VEHICLE PREP)
1.1
Disconnect the negative battery cable.
1.2
If equipped, remove and set aside the SMV sign.
1.3
Remove and discard the left rear fir tree clip holding
down the floor mat. See Figure 1.3.
1.4
Remove and save all the fir tree clips from the right floor
mat and temporarily remove the mat. Punch a 5/8" hole
in the center of the underside-indent in the mat in the
location shown. See Figure 1.4.
1.5
Remove and discard the M8 bolt in location shown in
Figure 1.4.
1.6
Re-install the right side floor mat using the fir tree clips
removed earlier.
1.7
Install the supplied aluminum spacer in the hole in the
right side floor mat. See Figure 1.7.
1.8
Loosen the nuts on the rear flashers and slide them out
of the brackets. Keeping the wires attached, let the
flashers rest on the rear fenders out of the way. See
Figure 1.8.
1.9
If installed, remove left side step and save all hardware
for re-installation later. See Figure 1.9.
1.10 If a rear SCV is installed, disconnect the hoses from the
SCV and remove from the ROPS. Refer to the SCV
installation instructions for installation after the cab is
complete.
Fig. 1.9 (Remove And Save Step)
CAB INSTALLATION
Remove and
Discard
Fig. 1.3 (Remove Left Rear Fir Tree Clip)
Spacer
Fig. 1.4 (Punch Hole in Right Floor Mat)
Spacer
Fig. 1.7 (Install Spacer)
Rear Flasher
Fig. 1.8 (Move Rear Flashers)
4 of 29
Remove Bolt
Punch 5/8"
Hole
Advertisement
