Advertisement
STEP 8: (WINDSHIELD)
8.1
Check the windshield support for squareness to the side
frames and tighten the two screws to 12.5 ft.-lbs.
8.2
With assistance, set the windshield up to the side
frames and secure it to the windshield support using the
hinge spacers and hardware. See Figure 8.2. Leave
hardware loose.
Hardware Used
5/16-18 x 1.5" Flat Head Screw
5/16-18 Hex Nut
Tools required
#3 Phillips screw driver
½" wrench or socket.
8.3
Close the windshield while lifting up on the bottom edge.
Tighten hinge hardware. Caution: The windshield
hinges are plastic components. Do not overtighten
the flat head screws. Torque to 7 ft.-lbs. max.
Tools required
Torque Wrench
8.4
Ensure the windshield latches function properly and the
windshield pivots open.
8.5 Remove the over-tightening caution decal from the top
of the windshield.
STEP 9: (WINDSHIELD WIPER
MOTOR)
9.1 Mount the wiper motor to the windshield. See Figure
9.1.
NOTE: Do not install the wiper arm and blade at this time.
Once all the wiring is complete and power is restored, it
can be turned on and off to ensure that the wiper arm
will be parked in the correct position once it is attached
at a later step.
STEP 10: (ROOF)
NOTE: If installing a Backhoe Compatibility Kit, refer to the
Backhoe Compatibility Kit Installation Instructions for the
roof installation and then proceed to step 11 of these
installation instructions.
10.1 With assistance, set the roof on top of the cab. Loosely
secure with sealing washers on the (8) screws through
the top of the roof. See Figure 10.1.
Hardware Used
5/16-18 x 3/4" Hex Head Screw
5/16" Sealing Washer
5/16-18 Hex Nut
Tools required
1/2" Wrenches and/or Sockets
CAB INSTALLATION
Qty
4
4
Qty
8
8
4
Hinge Spacer
5/16-18 Flat
Head Screws
Fig. 8.2 (Attach Windshield)
Plastic Washer
Hex Nut
Rubber Washer
Large Collared
Bushing (inside)
1/4-20 x 5/8" Screw
1/4" Int. Tooth Lock Washer
Fig. 9.1 (Windshield Wiper Motor)
(8) 5/16-18 x 3/4" Screws
and Sealing Washers
5/16-18 Nuts
Fig. 10.1 (Install Roof)
8 of 29
5/16-18
Nuts
Cap Nut
Steel
Washer
Rubber Washer
Small Collared
Bushing (Inside)
Advertisement
