Advertisement
STEP 22: (ACCESSORIES)
22.1 Install any optional accessories at this time.
22.2 Optional Rear Wiper Note:
For easier wiper motor harness disconnection, cut the
main wiring harness connector off a few inches from the
end and create a jumper harness with it using bullet
connectors. Do not cut the connector off the wiper
motor.
Strip all the wires, crimp a male bullet connector onto
the ground (black) wire of the main wire harness and a
female bullet connector on the positive (red) wire.
Reverse the male and female bullet connectors on the
new jumper wire harness so that the male bullet
connector is on the positive (red) wire and the female
bullet connector is on the ground (black) wire.
22.3 If a rear SCV was previously installed, refer to the Rear
SCV Installation Instructions now for re-installation.
CAB INSTALLATION
20 of 29
Advertisement
