Battery Connection - Elation KL PANEL XL IP User Manual

B AT T E R Y C O N N E C T I O N
This device is capable of receiving power from a battery pack.
NOTICE: The user is responsible for ensuring compatibility between the device and the
battery pack. Always ensure that the output specifications, operating conditions, and
connection pinouts of the battery pack match the device requirements.
The device features a 4-pin XLR connector for battery power. The connector is located on
the back of the device, next to the DMX In/Out connectors, and is covered with a dust cap.
BE CAREFUL NOT TO CONNECT BATTERY POWER TO ONE OF THE DMX CONNECTORS BY
MISTAKE!
Pinout Diagram
Consult the Safety Guidelines section of this user manual, as well as any safety instructions
included with your battery pack before use or installation.
The device consumes up to 544W when operating all LEDs at full output, which may require
significant battery output to provide the required power. To extend the battery life, it is
possible to reduce the LED power by up to to 50% of maximum output using the "LED Power
Limit" menu in the Personality section of the system menu. Please refer to the System Menu
section of this manual for detailed information.
Pin
1
2
3
4
20
Assignment
GND
+24-36VDC