Elation KL PANEL XL IP User Manual page 15

I N S TA L L AT I O N I N S T R U C T I O N S
STAND MOUNT INSTALLATION
This device is capable of being stand mounted by following the steps below:
1. Install the Junior Pin, as detailed elsewhere in this section.
2. Lock the mounting bracket in place by tightening both bracket knobs.
3. Insert the Junior Pin into the top of the Tripod Stand. Align the through-hole on the
Junior Pin with the holes in the top of the Tripod Stand, then insert the Locking Pin
through the hole and fasten in place.
4. If necessary, loosen the bracket knobs, adjust the fixture to the desired position, then
tighten the bracket knobs to lock the fixture in place. Use caution to prevent the Tripod
Stand from tipping over during adjustment.
See the picture below for reference:
15