Clamp Installation - Elation KL PANEL XL IP User Manual

I N S TA L L AT I O N I N S T R U C T I O N S

CLAMP INSTALLATION

A junior pin can be attached to the mounting surface on the fixture's mounting yoke, and this
junior pin can then be used as an attachment point for a mounting clamp. Details on junior pin
installation can be found in the Accessory Installation section of this manual.
The device also features a safety cable loop on mounting yoke hinge nearest to the DMX
ports (see the illustration below for reference). When mounting the fixture to a truss or any
other suspended or overhead installation, be sure to secure an appropriately rated clamp
(not included) to the junior pin and attach a separate SAFETY CABLE of the appropriate
safety rating to the safety cable rigging point. In the event that the optional barn doors are
installed on this fixture, a secondary SAFETY CABLE is also required to be attached to the
barn doors, as shown in the image below. For information on barn door installation, please
refer to the Accessory Installation section of this manual.
ALWAYS ATTACH A SAFETY CABLE WHENEVER INSTALLING THIS FIXTURE IN A
SUSPENDED ENVIRONMENT TO ENSURE THAT THE FIXTURE WILL NOT FALL IF
THE CLAMP FAILS.
RIGGING
Overhead rigging requires extensive experience, including but not limited to: calculating working
load limits, understanding the installation material being used, and periodic safety inspection of
all installation material and the fixture itself. If you lack these qualifications, do not attempt to
perform the installation yourself. Improper installation can result in bodily injury.
13