SawStop CTS-120A60A Owner's Manual page 40

2. Place a straight-edge against the riving knife and
along side the blade plate (not against the teeth).
This illustration is as if looking directly down on the
table and shows the gap between the straight-edge (A)
and the blade plate (B), when the riving knife (C) is
centered. The image also shows a tooth on the top of
the blade (D) and a tooth on the bottom of the blade (E).
C
B
D
E
3. To confirm alignment, use the feeler gauge to check
the gap between the blade plate and the straight-
edge. The gap should be 0.15 mm (0.006"). In this
example, the gap is 0.20 mm (0.008"). This means
the clamp has shifted to the right.
|
40 SawStop
®
A
0.15 mm (0.006")
0.20 mm (0.008")
Compact Table Saw
Turn the three clamp mount screws an equal amount
to adjust the alignment of the clamp. In this case, you
turn the screws clockwise to shift the clamp to the
left.
5. For access to the lower screw, open the dust
shroud door: use a flat-blade screwdriver or
similar tool to release the latch.
6. Pivot the dust shroud door open.
7. Use the included 4 mm hex-key wrench to turn
each screw (A) a small and equal amount
clockwise.
A
A
A