From The First Contact To The Output Coil - Eaton EZD Series User Manual

I 01
L: 1 C:1 B:7944
I 01 Ê
L: 1 C:1 B:7944
I 01 I 02
L: 1 C:2 B:7944
-I 02 Ê
L: 1 C:3 B:7944
MN05013005E
Creating your first circuit diagram

From the first contact to the output coil

With EZD, you work from the input to the output. The first input
I 01
contact is
Press OK.
EZD proposes the first contact
I
flashes and can be changed, for example, to a
pushbutton input using the cursor buttons
nothing needs to be changed at this point.
Press OK 2 ×, to move the cursor across the
second contact field.
You could also move the cursor to the next contact field using
í
the cursor button.
Press OK.
Again, EZD inserts a contact
Change the contact number to
can be connected to input terminal I2.
Press OK so that the cursor jumps to the next position and
press cursor button
You can press DEL to delete a contact at the cursor
position.
Press OK to move the cursor to the third contact field.
You do not need a third relay contact, so you can now wire the
contacts directly up to the coil field.
For more information visit: www.EatonElectrical.com
.
I 01
I 01
at the cursor position.
I 02
, so that break contact S2
Í Ú
or to change the number to
at the cursor position.
P
for a
Í Ú.
or However,
01
to the
02
.
89